Editorial Article

A Van Tyre Costs 1.05 Cents a Kilometre. Electrify the Van and It Costs Up to 2.77 — and the Tyre's Price Does Not Move

Updated November 21, 2026

A set of four light commercial tyres costs USD 474.16. Over 45,000 kilometres that is 1.05 US cents a kilometre, and that number is the entire economics of a working van, compressed into one figure.

Now put the same four tyres on an electric van. The tyres do not change. The price does not change. The kilometres do. Depending on the tyre and the duty cycle, the same set covers somewhere between 38 and 65 per cent of the distance it covered before, and the cost per kilometre rises to somewhere between 1.62 and 2.77 cents.

That is a 54 to 163 per cent increase in the tyre line of a fleet’s operating cost, arriving on a vehicle the industry is being compelled to buy, and the tyre manufacturer captures almost none of it as price. This is the article about why.

The arithmetic, shown

Start with the base. Pheonix’s light commercial vehicle tyres report puts realised price at USD 118.54 a tyre in 2025. Four of them is USD 474.16 a set. At a 45,000 kilometre working life — a reasonable figure for a C2 tyre on mixed regional duty — that is USD 0.01054 per kilometre.

Hold that figure, because it is doing more work than it looks. A fleet does not buy tyres; it buys distance, and the tyre is the denominator of that purchase. Every procurement decision in a transport business is an attempt to move the cents-per-kilometre number down, and the reason tyre buyers behave the way they do — the retreading arguments, the casing management programmes, the obsession with brand consistency across a fleet — is that they are managing a per-kilometre number that nobody outside their own operation can see.

Three reasons an electric van eats tyres

All three are physics, and none of them is about driving style.

Mass. A battery pack is heavy, and every kilogram of it is carried by four contact patches. Mass raises the normal force at the tyre, and wear scales with it.

Torque. An electric motor delivers maximum torque from zero speed. The longitudinal force at the contact patch is what erodes tread, and an electric drivetrain can apply more of it, more often, than a diesel one.

Regenerative braking. This is the one people miss. A regenerative system recovers energy through the drive axle, which means a disproportionate share of the braking force passes through two tyres instead of being spread across four brakes. The two tyres that already do the traction work also absorb most of the deceleration work.

Michelin’s own white paper on electric trucks and buses, published in December 2024, states the mechanism without hedging: “On an electric truck, the drive axle is subject to higher torque and consequently higher wear because of the energy regeneration system… the front axle will also be exposed to higher wear levels due to the heavier load.”

What the simulation found

The most detailed quantification available was presented to the HVTT forum, and it is a simulation rather than a measurement — for a reason the authors are explicit about, which is that battery-electric vehicles are not yet in service in sufficient volume to compare fleet tyre-mileage statistics. So they built a finite-element tyre model with a rubber-erosion law and drove it through OEM powertrain and vehicle-dynamics simulations, comparing diesel and battery-electric trucks on two duty cycles.

The results, on the drive axle:

  • Wear rate increased by 40 per cent on a regional delivery duty cycle.
  • The regenerative-braking contribution to wear more than doubled — up 120 per cent.
  • Across duty cycles, the estimate was +7 per cent on the steer axle and +25 per cent on the drive axle for long haul, and +10 per cent steer and +40 per cent drive for regional.
  • The tread-depth difference between the centre and the shoulder of the tread is expected to grow by more than 2 millimetres by end of life, which further reduces usable mileage.
  • Some isolated cases, the authors note, “already show -50% mileage on the drive position”.

Those figures are described by the authors as conservative, because they exclude load-transfer effects and the worsened wear profile. The load-transfer point is worth one sentence: when the drive axle brakes the vehicle by itself through regeneration, the resulting load transfer unloads that axle, which increases slip, which increases wear. It compounds in the wrong direction.

What the road testing found

Simulation on heavy trucks is one thing; a measured result on light vehicles is better evidence for a van. A study published in 2026 in Mechanics ran four commercially available tyres on conventional and electric platforms under controlled route conditions, measuring tread-depth reduction, wear uniformity and wear-pattern distribution.

Its conclusion: “For the tested tire specifications, tread-wear-based mileage on electric-vehicle platforms was markedly lower than on conventional platforms, with the strongest reduction observed on the front axle. Depending on tire type, the estimated mileage reduction from ICE to EV ranged from approximately 35 % to 62 %.”

The authors attribute it to “the combined effect of higher vehicle mass, instantaneous torque delivery and regenerative braking”, and note that the effect intensifies “especially under urban and stop-go EV duty cycles” — which is precisely what a delivery van does.

So what does the kilometre cost now

Take the measured range rather than the simulated one, because it is the more conservative choice and it is measured on light vehicles.

At a 35 per cent reduction in mileage, the same set covers 29,250 kilometres, and USD 474.16 over that distance is USD 0.01621 per kilometre.

At a 62 per cent reduction, it covers 17,100 kilometres, and the figure is USD 0.02773 per kilometre.

Both are the same tyre, at the same unit price, bought by the same fleet. The only thing that has changed is how far it goes. And 2.77 cents a kilometre, for a vehicle doing 40,000 kilometres a year, is a little over USD 1,100 a year in tyres per van — against roughly USD 420 on the diesel equivalent.

Who pays, and who does not

The fleet pays. That much is arithmetic.

The more interesting question is why the tyre manufacturer does not capture any of it, and the answer is a gap in measurement rather than a gap in negotiation.

A light commercial tyre has no published wear grade. In Europe, UN Regulation No. 117 imposes and labels wet grip, noise and rolling resistance, and UN Regulation No. 186 — the abrasion regulation — applies at §1.1 to class C1 passenger car tyres only, with the light commercial class C2 arriving through Regulation (EU) 2024/1257 on 1 April 2030. In the United States, FMVSS 119 reaches light truck tyres only at a tread depth of 18/32 inch or greater, and the Uniform Tire Quality Grading rule at 49 CFR 575.104 applies to passenger car tyres and expressly exempts deep-tread tyres.

So a fleet comparing two van tyres has purchase price, brand and service to work with, and no wear number. Confronted with a tyre that will do 35 to 62 per cent fewer kilometres on its new electric van, the buyer’s rational response is to shop harder on price — because price is the only variable it can observe — and the seller’s rational response is to compete there.

The wear penalty therefore arrives as volume, not as price. The fleet buys one and a half to two and a half sets where it used to buy one. The unit line grows and the price line does not.

You can see it in the market’s own numbers

That mechanism is not a theory; it is legible in the decomposition of this market’s growth. Of the USD 50.4 billion the light commercial tyre market adds between 2025 and 2033, 52.21 per cent is more tyres, 36.63 per cent is a dearer tyre and a richer mix, and 11.17 per cent is interaction.

Set that against the incumbents’ own disclosure and the divergence is stark. Pirelli reported 2025 revenue drivers of volume +0.4 per cent and price/mix +3.8 per cent — the industry being paid roughly nine times as much for price and mix as for volume. Michelin pushed 18-inch-and-larger tyres to 68 per cent of MICHELIN-brand passenger car sales, from 65. Pirelli lifted High Value to 79 per cent of revenue, from 76.

That is a tyre industry trading up into rim diameter and premium segments. Light commercial tyres have no equivalent ladder to climb. There is no premium attribute in a C2 tyre that a fleet will pay extra for, so the value there is created by counting units, not by moving buyers up a range.

The other reason the volume keeps coming

There is a second structural reason this market’s units track wear so closely, and it is not electrification.

Retreading absorbs roughly 23 per cent of European commercial vehicle replacement volume and under 1 per cent of passenger car volume, according to a UNECE working document on the retread market. Light commercial tyres sit in the lower bucket. The reason is physical, and a Bridgestone-commissioned study on European truck tyre retreading says so in parenthesis: “the light vehicle market has too much dimensional variety for retreading processes to be applicable”.

A retread line amortises tooling across a size. Truck tyres concentrate into a handful of sizes. Van tyres fragment across rim diameters, aspect ratios, load indices and C-marked variants, so the casing pool never concentrates enough to make the process pay.

The consequence is that a truck tyre sells roughly one new tyre plus a fraction of a retread per replacement event, while a light commercial tyre sells one, in full. Every kilometre worn is a tyre bought. There is no cushion and no lag.

And the fleet is electrifying faster than any other

The direction of travel is not in doubt. ACEA’s 2025 data has EU van registrations down 8.8 per cent overall, with diesel down 12.8 per cent to 1,168,561 units and an 80.7 per cent share, from 84.4 per cent a year earlier. Against that, electrically chargeable vans reached 11.2 per cent of the market, from 6.1 per cent — close to a doubling of share in a single year, in a falling market.

The policy ratchet is set. Regulation (EU) 2023/851 raises the 2030 fleet-wide CO2 target for new vans to a 50 per cent reduction from 31 per cent, with a 100 per cent reduction from 1 January 2035, and it keeps heavier electric vans inside the light commercial regime where the extra mass comes only from the battery — a deliberate choice to stop the heaviest electric vans escaping into a different category.

So the fastest-growing powertrain in the class is the one that wears tyres 35 to 62 per cent faster, in the tyre class with no wear grade, in a market with no retread cushion.

Two readings, both defensible

The first is that this is a volume annuity. Structurally secure demand, one-for-one with wear, no substitution route, and a policy tailwind that adds wear. For a manufacturer with capacity and a cost position, that is an attractive shape.

The second is that it is a cost problem nobody can price. A fixed compliance cost arriving in 2030, a price line tracking raw materials at 2.45 per cent, an input basket that moves faster than that, and a customer who buys on invoice because no other number is on offer. For a manufacturer without a cost position, that is a squeeze.

Both readings are true at once, which is why the market can grow 5.92 per cent a year and still be the least profitable place in the tyre industry to compete on price alone.

What changes it is a number. From 1 April 2030 a C2 tyre sold in Europe must hold a type-approval against an abrasion limit, and on that date a fleet can put two tyres side by side and buy the one that lasts. When wear becomes gradeable, the cents-per-kilometre figure stops being private fleet knowledge and becomes a purchase specification — and the price line acquires the one thing it has never had, which is something other than the invoice to anchor it.

How that regulation is drafted, and why it reaches the passenger car tyre twenty-one months before the van tyre while American law exempts the deep-tread light truck tyre altogether, is set out in the companion piece: One Regulation Measures How Fast a Tyre Wears. It Excludes the Tyres That Wear Fastest.

References

  • Pheonix Research, Global Light Commercial Vehicle Tyres Market, 2026–2033 — pheonixresearch.com
  • Gelbal, M. and Karaoğlan, M. U., “Experimental Comparison of Tire Tread Wear Performance on Conventional and Electric Vehicles under Controlled Road Conditions”, Mechanics, 2026 — mechanika.ktu.lt
  • HVTT forum, paper 798, on the impact of electric powertrains on tyre wear (simulation) — hvttforum.org
  • Michelin, white paper on electric trucks and buses, December 2024 — michelin.com
  • UNECE GRBP-78-29, EU retread market shares — unece.org
  • EY for Bridgestone, “The socio-economic impact of truck tyre retreading in Europe” — bridgestone.com
  • ACEA, new commercial vehicle registrations, full year 2025 — acea.auto
  • Regulation (EU) 2023/851 amending Regulation (EU) 2019/631 (light commercial vehicle CO2 standards) — EUR-Lex
  • Regulation (EU) 2024/1257 (Euro 7), consolidated text — EUR-Lex